 |
||||||||
Card Making Project - Vintage Car Wedding Invitation
Made by Jacqui
This card uses 2 dies from Marianne Design - Creatables Model T Ford and Anja's Roses Large Corner to create a wedding invitation with a difference.
You will need a die cutting machine for this project.
|
||||||||
 |
To make this card you will need:
 A4 White Hammer Card Smooth Black CardCore'dinations 12 x 12 Tim Holtz Distress Cardstock - Bundled SageMarianne Creatables Model T FordMarianne Anja's Roses Large CornerD'Vine Swirls Embossing FolderDie Cutting Machine - Cuttlebug, Big Shot or Grand CaliburBridal White Organdie Ribbon - 15mm WideSelf Adhesive 10mm Gold HeartsWedding/Evening Invitation/RSVP Peel Offs in Gold5mm Double Sided Tape3D Double Sided Foam Pads 10mm Square Low Tack Masking TapeScoring Board such as the EaziScore or Hougie Board |
|||||||
Cut the A4 white hammer card in half (148mm x 210mm) and then score down the middle of one piece to create an A6 (148mm x 105mm) creased card.
Open the card out and place the Anja's Roses Large corner die in the upper right corner of the front of the card. As this die is a cut into card die it is important that it doesn't move whilst going through the die cutting machine so secure in place using a little low tack masking tape. Run it once through the die cutting machine to cut it then change plates and run through again to emboss it.
If you are unsure which plates to use for your machine see the Blog article on Using Cutting and Embossing Dies.
Cut a piece of the Bundled Sage card to measure 105mm x 50mm and run it through the die cutting machine using the D'Vine Swirls embossing folder. Wrap a piece of bridal white ribbon around the middle of the card securing in place with double sided tape. Using double sided tape glue into position of the card approximately 1 cm from the bottom of the card.
Using a piece of the black smooth card and the Marianne Creatables Model T Ford die run it once through the die cutting machine to cut it and then, changing plates, run it through again to emboss it. Place a self adhesive gold heart of the die cut car. Attach to the card using 3D foam pads.
Place the Wedding Invitation towards the upper left of the card.
********************************
Please feel free to copy this card for your own use. Our angel policy can be accessed via the Gallery home page.
__________________________________________________________________________
|
||||||||
 |
||||||||
